ExcelPTZ PTZ605 series Instrukcja Obsługi Pobierz pdf (Strona 24)

Patrols (Tours) – How to set them up and use them

A patrol (tour) is simply a collection of at least three preset camera locations that are run in sequence with

the dome stopping at each location for a brief period of time and then moving on to the next preset.

For example, you could use a patrol so that an outside dome camera points at a gate, then at a side doorway,

then zooms out to get an overall shot of a car park and finally zooming in on a delivery bay, before repeating

the whole cycle again. Patrols can be useful for both outside and internal PTZ’s. For a shop they could be

used to cover key areas like clothes rails, tills and changing rooms in a sequence.

To set up a patrol you need to set up the individual stop points where the camera will pause. These are called

presets.

An example four preset mini-tour

Setting the presets using the keypad

STEP 1- Using the keypad joystick, move to where you wish to start the tour and then press <PRESET>

01<Enter>

STEP 2- Now move to the next location and press <PRESET> 02 <Enter>

STEP 3- Now move to the third location and press <PRESET> 03 <Enter>

STEP 4- Finally move to where you wish to end the tour and press <PRESET> 04 <Enter>

Deleting a preset

You may wish to delete a preset.

To do this press <PRESET> xx <Enter> holding the preset button down for 3 seconds at the end.

(xx = preset number).

For example to delete preset 1, press <PRESET> 01 <Enter> (holding the preset button for 3 seconds)

Obviously if you wish to overwrite a preset with a new location, simply aim the camera at the new location

and store the preset as normal, this will simply overwrite the old preset.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 57 58

Brak uwag

ExcelPTZ PTZ605 series Instrukcja Obsługi Strona 24